Solderless Stevie Ray Vaughan drop-in deluxe wiring harness
Hand built by us here in the Uk, this configuration is identical to that used in vintage 50' guitars and also in the famous SRV Strat.
Standard configuration of tone control on neck and middle pickups. Bridge pickup is straight through with no tone control.
USA made parts - Reliable & robust
We use parts of the highest quality for these harnesses. They are built utilising Eric Johnsons "floating wire" technique to reduce hum and other interference.
For those who aren't too confident with a soldering iron, this is a fantastic solution. Just connect your pickup wires to the colour coded connecting block, do the same with the two wires from the output jack (supplied), and you're ready to go. The whole job takes less then 5 minutes, and no chance of buring down the house!
Contents of the SRV wiring harness:
1 x Genuine USA made CRL heavy duty switch
3 x CTS vintage dimple back Audio Taper pots (250K)
1 x Genuine Sprague Orange Drop Cap (0.022uf)
Vintage cloth covered wire (USA Made)
1/4" Mono output jack
All fitted to our custom aluminium control shield (helps reduce hum, and eliminates the need for the 3 point wiring to the back of the pots)
Hand built in the UK
All of our wiring harnesses are assembled by us here in the UK using high quality silver solder and USA made vintage cloth push-back wire. We even solder the output jack so the whole this is ready to drop-in.
All parts are fitted to our aluminium control shield there’s no need to dis-assemble the parts to fit them to your scratchplate. Simply add the whole assembly to the underside of your scratchplate and it’s done!
Please note: These harnesses are built to order by us here in the UK so please allow 48 hours for us to assemble and despatch your order.
This is a fantastic product using the top components. Quiet and clean and so easy to install you could actually change pickups as easily as changing strings (almost). Only downside is I want another one and you can never get hold of them!